Battery Safety Precaution

All EAGTAC flashlights are designed to use “button-top?battery (battery with protruding positive terminal). For rechargeable li-ion battery, use only EAGTAC li-ion battery, or other protected li-ion battery with compatible length and diameter. Before using the battery, check and ensure the battery outer wrapping (the isolating plastic film that wraps around the metal housing of the battery) is complete. Broken battery wrapping may lead to short circuit and damage to the flashlight.

Lithium and Li-ion battery can explode or cause burns if disassembled, shorted, or exposed to high temperature. Do not mix new and used batteries. Do not mix batteries with different brand, capacity, voltage, or install batteries backwards.

NiMH rechargeable battery may release gas during discharge. If you experience an inflated switch boot or find high pressure being built inside the flashlight, switch off the flashlight immediately. Slowly loosen the tail-cap to reduce the internal pressure and replace all batteries.     Back to top

Flashlight Maintenance

Cleaning: Periodically clean the thread and o-rings with a lint free cloth. Clean the battery contact, signal contact, thread, and body contact (conductive aluminum area) with a lint free cloth. Do not touch or attempt to clean the reflector, as it will scratch the reflective coating permanently

Lubing: Apply a thin coating of EAGTAC silicon-based lubricant to the o-rings (not the machined thread)and use a small drop of Deoxit red cleaner solution (D series) to slightly lube them for better conductivity and smoother mode switching experience.

Accessories